Main Connector Page
- High ending loudspeaker patch
cords genuine-gilds 24 carat
- 8 mm of fork opening
- 25° bent fork
- Transparent isolation case to the protection against
- Cable admission up to 8 mm
- 2 large adjustment screws for the strong stop of the loudspeaker
cables in the plugs
- Very comfortable and easy assembly
The TS of lugs was developed for the firm installation and/or screw
connection by loudspeaker cables at loudspeaker sockets. With 2 mm a
strong fork are screwed firmly the lugs onto terminal clamps. Thus a
durably firm contact is ensured.
More information can be found
at the Viablue Website.
(8MM) Spade Connector (Pair)
(1) red band & (1) black
Loudspeaker cables can
be installed in TS plugs very easily and comfortably. For this a
skinning device for stripping the cables as well as a screwdriver
are only needed for fastening the cables in the patch cords.
The loudspeaker cables should with a length of approx.. 8 mm to be
stripped and then into the housing inside of the TS of plug
connector be put firmly. This internal part of the TS patch cords
narrows itself in such a way that the air supply is pinched off when
correct putting in. Thus the braids are protected against oxidation.
The cable can be tightened comfortably by the two large adjustment
screws. The cable has thus a very strong stop in the plug. Soldering
is not necessary.
Back to Main Connector Page
& Granite Audio
PO Box 7591
Salem, OR 97303
See our our other sites: